Remove peel coat from inserts.If bottom platen is cold, begin by preheating for 15 seconds.
1) Lay protective paper on heat press platen. 2) Remove protective film from insert. 3) Lay insert imaging side face-down on transfer. Use heat tape or Pro Spray to keep it in place. 4) Add a piece protective paper over your transfer and insert. 5) Press. Add 2-3 seconds for each additional insert imaged at the same time. Too much pressure will cause a mottling of the metal finish. Use the weight of the platen as pressure if necessary.
NOTE: If you should see a void in the provided glue layer, add a drop of Super Glue to those areas prior to assembly of the product.
Should your phone case become soiled with use and wear, remove it from the phone and clean it with an ordinary household strength glass cleaner. Any remaining discoloration can be scrubbed off using glass cleaner and a non-scratch Scotch-Brite pad.